Scan Interval
Posted: Fri Dec 03, 2010 11:57 pm
Can someone explain the significance of the Scan Interval property? I have a few Data Matrix and QR barcodes that are distorted that I am trying to test and it seems that tweaking this property gives me different results.
Setting the default value of 5 sometimes works. Sometimes moving it up or down seems to effect whether or not the software will read the barcode. Obviously the lower the value, the longer it takes and the higher the faster.
I have no clue what the lower and higher values mean and hoping someone can shed some light on the this matter.
Also what is the best practice for scanning some barcodes that do not work? Should we start with the default value of 5 and then work our way up or down? What would you recommend? Should we multithread the application to read various scan intervals at a time?
Thanks
Setting the default value of 5 sometimes works. Sometimes moving it up or down seems to effect whether or not the software will read the barcode. Obviously the lower the value, the longer it takes and the higher the faster.
I have no clue what the lower and higher values mean and hoping someone can shed some light on the this matter.
Also what is the best practice for scanning some barcodes that do not work? Should we start with the default value of 5 and then work our way up or down? What would you recommend? Should we multithread the application to read various scan intervals at a time?
Thanks